This Mustang kit has enough hose to handle any stock 5.0 built from 1979 to 1995. It has the extra length often required on modified Mustangs. The car pictured is a 93' Cobra with a Vortec supercharger. It comes in length with a hose cutter and installation instructions.  

each kit

     This kit has a minimal amount of hose for race cars that no longer have most of their emissions equipment. It's intended for 1979-1995 cars although it will work fine on earlier Mustangs.  It comes in length with a hose cutter and installation instructions.

each kit

     The Mustang SVO kit replaces all the vacuum hoses under the hood, and I mean all of them. It also replaces a couple of the smaller diameter coolant hoses. Note: the engine in the picture is a Thunderbird Turbocoupe. The SVO kit is a little different. It does not include the pictured hose for the windshield washer or cruise control. It is not a pre-cut kit, but we do include a hose cutter to make the job easy. The Ford turbo 2.3 uses a lot of vacuum hose, and it controls a lot of important systems. If your car still has it's original hoses you will almost certainaly notice an improvement in engine response, idle and turbo spool up time. This kit has about 40 feet of hose in four sizes.

each kit

[up]

     This kit replaces all vacuum lines associated with the fuel injection.  It comes in length with a hose cutter and installation instructions.

each kit

     The Thunderbird TC kit replaces all the vacuum hoses under the hood, and I mean all of them. It also replaces a couple of the smaller diameter coolant hoses. Note: the engine in the picture is an'87-'88 Thunderbird Turbocoupe. The eary TC kit  is a little different. It does not include the pictured hose for the windshield washer or cruise control. It is not a pre-cut kit, but we do include a hose cutter to make the job easy. Silicone hoses really help the Ford turbo 2.3. It's very sensitive to air leaks.

each kit

     This is a pre-cut kit with 32 hoses totalling about 42 feet in four sizes. It replaces every vacuum hose under the hood as well as all the windshield washer hoses. We included the hoses for the boost gauge and cruise control that are hidden under the dash and in the wheel well. Many of the TurboCoupe's systems are vacuum controled including the boost control, fuel pressure, EGR, PCV, cruise control and more. Leaks in the vacuum system can cause all sorts of problems in these cars. This kit includes step by step instructions with tech tips and pictures to help with installation.

each kit

    This kit includes two reinforced silicone couplers and four stainless steel T-Bolt clamps to attach the Turbocoupe's intercooler to the turbo and throttle body. These are far superior to the factory hoses. They help eliminate power robbing and lag causing boost leaks. We noticed a significant improvement in turbo spool up time when we installed these couplers and a new silicone vacuum kit on our '88 Turbocoupe. We guarantee these will never burst under turbo boost regardless of how much you crank up the boost with your factory turbo. They are very high quality. (note: they are slightly longer than the factory couplers. We have found that makes them easier to install and has no negative effects on performance. They can be trimmed to stock length if desired)

each kit

     This kit includes five different sizes of silicone hose. It will replace every vacuum line under the hood of this car as well as all of the windshield washer hoses. This kit does include the large diameter breather hoses attached to the valve cover etc.

each kit